1989 Chevy Camaro Race Car New engine build, corvette 6 speed selling whole car, lots of good parts....also car has clear title.... have any questions please feel free to call Jerry at 727 480 8336 have pictures will be happy to send to you !!. LARGO, FL 33773 (727) 584-6302 (727) 480-8336
Conversion set up includes: Transmission Shifter assembly Bell housing Fly Wheel Clutch fork Z-bar Clutch rod Pedal assembly steering column with wheel. LARGO, FL 33773 (727) 584-6302 (727) 480-8336
106k miles. Shifted through gears on lift (car was damaged) fine but not road tested. pretty clean, seems tight. Output shafts looked newish which could indicate previous rebuild.
I bought this from a shop where it had ben mounted in a kit car for years and rolled around. The car never was completed or ran and the parts were sold.
I installed this kit with 29k miles on my car and now I have ~32k. It is the complete kit with everything you'll need. AccuAir e-Level TouchPad Air Ride Kit Front Suspension Air Lift Performance Front Kit Rear Suspension Air Lift Performance Double Bellow Rear Kit Rear Shocks Bilstein Sport Rear Shocks Air Line Size 1/4" Controller Finish Black Anodize Air Tank Black Aluminum 4 Gallon End Port ...
Driver quality I know at least one cap is a repo all crests are enamel and one is orange stripe Buyer pays shipping
Basically its all the parts I have acquired over the years that I just no longer have a use for. My cars don't need these parts and I am no longer dragging home any that will. I also do not have the time or patience to sell everything off by the piece. Most everything is very organized and in labeled tubs. Please plan on bringing a trailer or a moving van. Most everything is '67 and earlier wit...
Looking for a either a parts car, shell, or an excellent condition roof clip. Must be '58 - '64 hardtop beetle. I need it cut at A pillars and to include engine vents with decklid attachment points, all in a single piece. In FL preferred, but I can likely have it picked up throughout much of the SE.
There are many variations of front apron, so if it is not exactly for a '61, I may be able to modify to get it "correct". Would like to see anything from that general era.
Looking for a new old stock 40hp engine case. Preferably with D shaped hole under generator stand and cut for camshaft bearings. Motivated buyer.
6750w Coleman runs and needs rope pull fixed. FREE you pick up in St Pete
All items shown included all will need rechromed or use as is. All but one are OEM I have repaired some of the mounting bolts Buyer pays for shipping can take more photos if interested
One year old, never used pair of harnesses, in original boxes. Clearwater, FL 33760 (727) 631-5900